Welcome to the official website of BORUNTE
Borunte Robot Co., Ltd+0086-400-870-8989
Two-Axis Robot

BRTYZGT04S2B

Two-Axis Robot

  • Simple Operation
  • Quick response
  • Safe And Efficient

Product Introduction

BRTYZGT04S2B type robot is a two-axis robot developed by BORUNTE. It adopts a new drive control integrated control system, with fewer signal lines and simple maintenance. It is equipped with a handy mobile hand-held operating teaching pendant; the parameters and function settings are clear, and the operation is simple and fast. The whole structure is driven by a servo motor and RV reducer, which makes the operation more stable, accurate, and efficient.

  • Accurate positioning

    Accurate positioning

  • Fast

    Fast

  • Long service life

    Long service life

  • Low failure rate

    Low failure rate

  • Reduce labor

    Reduce labor

  • Telecomm unication

    Telecomm unication

Basic Parameters

Applicable to die casting machine 400T-800T
Msnipulator Motor Drive(kW) 1kW
Tableapoon Motor Drive(kW) 0.75kW
Arm reduction ratio RV40E 1:153
Ladle reduction ratio RV20E 1:121
Max.loading(kg) 6
Recommended tableapoon type 4.5kg-6kg
Tableapoon Max(mm) 450
Recommended height for smelter(mm) ≤1100mm
Recommended height for smelter arm ≤500mm
Cycle Time 7.3S (The standby position moves forward and returns to the standby position after completion)
Main control power AC Single phase AC220V/50Hz
Power Source(kVA) 1.7kVA
Dimension length, width and height(1240*680*1540mm)
Weight(kg) 230

trajectory chart

No further notice if the specification and appearance are changed due to improvement and other reasons. Thank you for your understanding.

Precautions for Storage and Handling Caution:

Do not store or place the machine in the following environment, otherwise it may cause fire, electric shock or machine damage.

1. Places exposed to direct sunlight, places where the ambient temperature exceeds the storage temperature conditions, places where the relative humidity exceeds the storage humidity, or places with large temperature differences or condensation.

2. Places close to corrosive gas or flammable gas, places with a lot of dust, salt and metal dust, places where water, oil and medicine drip, and places where vibration or shock can be transmitted to the subject. Please do not grab the cable for transportation, otherwise it will cause damage or failure of the machine.

3. Do not stack too much products on the machine, otherwise it may case machine damage or failure.

Product Recommendation

Purchase Consultation